The choice of microphone should be based on the occasion of use and the requirements for sound quality, combined with the characteristics of various microphones, and comprehensive consideration should be given to the selection. For example, high-quality recording and broadcasting mainly require good sound quality. Condenser microphones, ribbon microphones or advanced dynamic microphones should be used; for general amplification, ordinary dynamic coils can be used; when the speaker moves from time to time Or when speaking, there is a large distance from the amplifier, such as karaoke singing, a unidirectional, low-sensitivity microphone should be used to reduce noise interference. The use of condenser microphones requires phantom power supply. Generally, the power supply voltage is stated in the technical parameters of the microphone. It is necessary to select a phantom power supply with an appropriate voltage. The mixer is generally equipped with 48V phantom power supply.
It should also be noted in use:
1. Impedance matching
When using a microphone, the output impedance of the microphone and the input impedance of the amplifier are the same as the best match. If the mismatch ratio is more than 3:1, the transmission effect will be affected. For example, when a 50Ω microphone is connected to an amplifier with an input impedance of 150Ω, although the output can increase by nearly 7Db, the high and low frequencies will suffer significant loss.
2. Connecting line
The output voltage of the microphone is very low. In order to avoid loss and interference, the connecting wire must be as short as possible. For high-quality microphones, you should choose a twisted pair metal shielded wire. Generally, a single-core metal shielded wire can be used for a microphone. The length of the high-impedance microphone transmission line should not exceed 5 meters, otherwise the treble will be significantly lost. The low-impedance microphone connection can be extended to 30m-50m.
3. Working distance and proximity effect
Usually, the working distance between the microphone and the mouth is 750px-1000px. If the distance is too far, the reverberation will increase and the noise will increase relatively; if the working distance is too close, the signal will be distorted due to the strong signal, and the low-frequency sound will affect the language. The clarity. This is because the directional microphone has a "close-talking effect", that is, the low-frequency sound will be significantly improved when speaking at a close distance. However, sometimes singers deliberately use the "proximity effect" to make the singing effect more beautiful and pleasant.
4. The angle between the sound source and the microphone
Each microphone has its effective angle. Generally, the sound source should be aligned with the center line of the microphone. The greater the deflection angle between the two, the greater the treble loss. Sometimes when the microphone is used, there is a "rumble" sound. At this time, you can reduce it by deflecting the microphone to a certain angle.
Note when using wireless microphones:
(1) Choose the location of the receiver to avoid the "dead point".
(2) When receiving, adjust the angle of the receiving antenna, tune the frequency, and adjust the volume to make it in the best state.
(3) The antenna of the wireless microphone should hang down naturally, out of the clothes.
(4) Prevent the battery's polarity from being reversed, and take out the battery in time after use.
Some microphones (such as electret condenser microphones, wireless microphones) are battery-powered. If the voltage drops, the sensitivity will decrease and the distortion will increase. Therefore, when the sound becomes poor, check the battery voltage, turn off the power switch when the microphone is not in use, and remove the battery when it is not used for a long time.
USB Microphone:https://www.soft-voice.com/
