Email:lucy@soft-voice.com USB microphone,Computer microphone, Wired microphone,Karaoke microphone ,Condenser microphone
News>Technical knowledge

Microphone fault service

Author:admin   AddTime:2021-02-04

The brain microphone doesn't sound how to set it
1, first check whether the microphone is muted, the control panel to find "sound." Switch to the Sound option, select the microphone, right-click to see if the microphone is disabled, and if disabled, cancel it to return to normal.
2, open the sound options in the control panel, enter the "Sound" dialog box, switch to the "Record" tab, directly double-click the "Microphone" option or right-click the "Property" command. Switch to the Levels tab, turn up the volume of Microphone and Microphone Enhanced, and click the OK button to make the settings work (Note: The microphone is too loud and hears a lot of echo).
3, check that the microphone is OK. Turn on Recording, and then click the button with Dot to start recording, then speak to the microphone, if the green horizontal line does not fluctuate to indicate that the microphone is broken or there is a problem with the sound card. If you pass the test and find that the microphone does not work properly, you can connect the microphone to another computer to try, also do not need to change the microphone, you can use that is the computer sound card drive or sound card hardware problems. More solutions>>.

What if the microphone has a noise?
1, may be a music sound quality problem, you can choose to cancel the audition to listen to this sound, and then choose to replace other music to see if there is such a situation.
2, hardware failure, check whether the microphone is intact, whether foreign objects fall into it, whether the edge of the vibration paper has been peeled off, damaged, if so, the microphone needs to be repaired or replaced.
3, the AC component in the circuit is too large may be the filter circuit of the speaker power supply failure, especially the filter capacitor. There is also a power supply problem, may be caused by the current sound, is a normal phenomenon.
4. There is a problem with the connection between the microphone and the computer host. Disconnect the microphone from the computer console, reconnect correctly, and see if there is any contact. This problem may occur if the microphone is in a enhanced state, just remove the microphone-enhanced.

5, to see if there is a magnetic field and sound wave around the material, such as mobile phones, fans and other equipment, with magnetic field electrical equipment can be taken away.


tage:Wire microphone  condenser microphone



Related Articles
Why can't catch on the microphone WangTou used?

Why can't catch on the microphone WangTou used?

2021-02-04

Many of the performers, in the use of hands grabbed the microphone WangTou manner, is severely damage…

Use the distance between the wired microphone and the mouth to understand?

Use the distance between the wired microphone and the mouth to understand?

2021-02-04

Singing with a pointed wired microphone, pay attention to take the microphone posture, because the mi…

What do you want to see if you want to pick a good quality microphone?

What do you want to see if you want to pick a good quality microphone?

2021-02-04

For those who do not have experience or expertise, want to enhance the quality of the sound, the choi…

About Us

Shenzhen Shuyin Technology Co., Ltd. is a high-tech enterprise integrating microphone, microphone, Bluetooth headset, electronic audio-visual products and peripheral accessories of electronic digital products into one.

Contact Us

Email:lucy@soft-voice.com
Operation Department Address: Zhonglian Tongtai Industrial Park, Liangan tianliangbai Road, Pinghu street, Longgang District, Shenzhen

Online Message Verification code
Shenzhen Shuyin Technology Co., Ltd. All rights reserved ©2020